.
Lengthened by increasing the length of a line that we set.
We can change the length of the line determined by the difference, measured from the end point that is closest to the point of selection.
Delta can also change the angle of the arc with a certain increase, measured from the end closest to the point of selection.






Steps we have to do is:
From the menu: Modify> Lengthen

Command: LENGTHEN
Select an object or [Delta / Percent / Total / Dynamic]:
Current length: 23.0210
Select an object or [Delta / Percent / Total / Dynamic]: de
Enter delta length or [Angle]> 60.0000, 25
Select an object to change or [Undo]:



  • Read more........
  • Share on :

    0 comments:

    Post a Comment

    top